Fancontrol fan1 new fancontrol11/24/2023 ![]() I’ll continue to look at this to see what I’m doing wrong to get the debugging. I have tried to get a debug log, but haven’t succeeded yet, for some reason when I use the karaf commands in the docker console, no additional logging is created. Am I supposed to cast it to a number like this to get the additional speed settings, or do I need to set it up a different way ? This does result in the selection updating to the correct value (On, Low, Off, etc) when the fan is changed via the remote, but the fan speed doesn’t change when the selection is updated in openhab. Selection item=Fan1_Speed_n label=“Fan Speed” But this is a very simple and thus limited way of adjusting the fan speed. Then you can set the fan speed according to the slider. Next, you'll need to flick the switch in the middle left of the card. Connect to 3 ST120 or 3 Bora Digital fans. To do this, click the button in the top right corner of a fan control card and check the option Manual control. Easy layout screen provides information on. Eliminate the need for a separate fan control by using the fan port on a. I have tried assigning the fancontrol channel to a Number as well as a switch Fan Control PRO provides acurate fans speed adjustment between 6-12V and temperature monitoring up to 99C. ![]() However the commit shows that it can be controlled by a DecimalType as well as a OnOffType. I do see the new zigbee fan control channel which shows as a switch and I can successfully use it to turn the fan on and off via openhab. I fired up a docker with recent snapshot, and the main page shows “openHAB 2.5.0 Build #1698”.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |